1 reply to this topic

[Chandler]

hi all

i recently acquired a small power computing external hard drive but the internal scsi drive has more bad sectors than good!

anyway i have a Seagate ST31051N to replace it with

but i can't get the atari to see it (using HD Driver 8 or ICD utilities)

basically can someone advise me on the how the jumpers on the Seagate should be set?

below is a link to the scsi board inside the power computing drive

AdSCSI Micro ST (top of the page)

http://www.icd.com/a...tml#adscsimicro

if the Seagate can't be used i also have the following drives

IBM H 3085-S1
IBM DSAS 3540
Quantum pro drive - again none of these can be seen by the atari


J2 jumper block options on Seagate ST31051N:

TP to bus
TP from bus
TP from drive
Reserved
Parity Disable
Write Protect
Motor start Enable
Delay motor Start
Term Enable

please advise what should be jumpered "ON" and what should be left "OFF"

[bid]

Hi,

Did you get the problem with the SCSI drive solved?

I am also having the same issues right now!! I have a Seagate ST3255W 2BG drive and I'm wanting to put on into a TT

Trouble is, that I am struggling also to guess the jumper settings. Its not as easy as it looks!!

Please advise if you got it fixed??!!

Kind regards,
Bid